![]() |
Auto-Provision CP860 3CX V12 - Printable Version +- Yealink Forums (http://forum.yealink.com/forum) +-- Forum: IP Phone Series (/forumdisplay.php?fid=4) +--- Forum: CP860 (/forumdisplay.php?fid=43) +--- Thread: Auto-Provision CP860 3CX V12 (/showthread.php?tid=12180) |
Auto-Provision CP860 3CX V12 - fonewiz - 01-21-2016 12:25 AM I would like to be able to auto-provision the CP860 from the extension setting in 3CX but when I click the Yealink dropdown, the CP860 is not listed. How can I get the CP860 to show up, auto-provision and use 3CX to upgrade the firmware, reboot phones etc? Thanks in advance for any assistance with this. RE: Auto-Provision CP860 3CX V12 - Karl_Yealink - 01-21-2016 06:10 AM Do you have send the same issue to our support email box. We had gave you respond via the email. Please check. RE: Auto-Provision CP860 3CX V12 - FurnicK - 03-22-2016 02:48 PM Is this issue resolved? I'm having the same issue, the CP860 is not listed in 3CX v14. RE: Auto-Provision CP860 3CX V12 - Bahntechnik - 04-05-2016 03:41 PM I solved this "problem" in V14. You have to add a provision template for the CP860. Therfor I modified an template for T46G. In the "models" xml-element you need to add the CP860: Code: <models> Code: <filename> Thats it. Save the template. You may need to check documentation of provisioning of the CP860. Not everything is possible. RE: Auto-Provision CP860 3CX V12 - DJ_HiP - 07-07-2016 11:01 AM I have just used the T19P E2 template, as the phone is essentially a T19P E2 with a better speaker. (Same control interface). It doesn't allow for firware upgrading etc, but its least an inbuilt template. |