Yealink Forums

T46g with firmware version 28.71.0.170 - trying to enable vpn and upload a tar with the vpn file and certs.

I go to network advanced, then under VPN I change the Active select box to Enabled.

I click the "Browser" button, browse to the openvpn.tar (which is on e:\openvpn.tar) and after I select the file from my E: drive, I click OK.

The uneditable textbox labeled "Upload VPN Config" reads "c:\fakepath\openvpn.tar".

I click upload and I get a success dialog with an OK button

I click OK and the browser refreshes the page.

The Active select is back to disabled, the path is blank and the confirm button responds that I should upload a file first.

Please help.

Hi grooveion,

Please make sure you name cnf as "vpn.cnf" in default, and re-pack as tar file.
Please try again.