Hello.
Why is it not possible to reduce the time out for dial-now rule to 0 seconds? I do not see the benefit of waiting one second, the minimum.
Regards.
I feel the same way. The phone should have the ability to dial as soon as a Dial-now rule is found.
Especially when the "Using Dial Plan Feature on Yealink SIP-T2XP Phones" guide says this (on page 3):
NOTE:
1) By default, the delay time for Dial-now would be 1 second
2) Configurable time would be 0~14seconds
Thanks,
Benoit
I have a 0 and its working fine, just put 0
(01-03-2014 09:35 AM)deutschnaftyula Wrote: [ -> ]I have a 0 and its working fine, just put 0
Neither T42 nor T46 allow setting value 0 for the dial-now time out. Both are on the latest firmware available: V72 (29.72.0.25 and 28.72.0.25)
0 seconds is not good. I can't dial a 7 digit local call hat is near match to an internal extension.
Ie
Internal extension 4954
Local number 495-4000
If I have wait set to 0 - then I always get 4954 and not 495-4000.
Just wanted to update this post.
In version 73 beta 2 release notes. It states
"Fixed the issue that Time Out for Dial-now Rule cannot be set to “0”.
I have tested it and zero does indeed work on the T46 and T48 now