Yealink Forums

FYI

After upgrading T20P to firmware version 9.71.0.140 users could only get 1MB per second transfer speed if they connect through the phone to network.

Resetting phone to factory settings didnt help.

Ive gone back to 9.70.0.168 - (Last 3CX supported FW)

Not sure if there is some QoS or Bridge throttling setting in new FW?

Hi Rudolf,
Could you upgrade to below firmware 9.71.0.144 to check again?
ftp://yealinkftp:yealinkftp@ftp.yealink.....0.144.rom
Thanks.

Hi Admin

9.71.0.144 fixed the transfer issue thanks!

Whats the rollout plans to test the FW for 3CX PBX?

Cheers

I had the same problem, and it was fixed with firmware 9.71.0.144, but I have another problem now.
When I try to call from Call Panel ( Directory->Phone call info), I get a widget that say "Call failed".
I there something I can do? This feature used to work.

Any news in calling from the Call Panel?

Hi gimak,

Please make sure you have enable IP address of PC in your webpage.
We add a secure feature that confine others to call out using URI, especially for hackers.
Please add the IP address that can control your phone.
( Please enter the webpage->Features->Remote Control->Action URI allow IP List, fill your IP address of PC in this place)

(10-31-2013 03:56 PM)Yealink Support Wrote: [ -> ]Hi gimak,

Please make sure you have enable IP address of PC in your webpage.
We add a secure feature that confine others to call out using URI, especially for hackers.
Please add the IP address that can control your phone.
( Please enter the webpage->Features->Remote Control->Action URI allow IP List, fill your IP address of PC in this place)

Worked perfectly for me

hi i have the same (1mbps) issue but on a t22 when are you planing to release this new firmware? thanks

Hi all,

About this pc port issue, we have fixed it and release below beta versions.

ftp://yealinkftp:yealinkftp@ftp.yealink....es/T2x/V71