Hi
Sorry for the delay, the Problem stay, it looks like better with the
Firmware,but not good, i think you are on the right way, to resolve the
problem.
What do you need of Files/Info analysis the Problem
thanks a lot for your help
christian
Hi griese,
Do you mean you still have one second pause in a call runing 2.61.0.160? Can you supply me new Syslog level 6, config.bin and pcap?
(12-09-2013 10:59 AM)Yealink Support Wrote: [ -> ]Hi griese,
Do you mean you still have one second pause in a call runing 2.61.0.160? Can you supply me new Syslog level 6, config.bin and pcap?
Hi
there are the log´s.
In this log we have the problem with the audio problem for the first second
2.61.0.160_15-42-2.pcap
----------------------
This log was the second call without the problem in the first second
~ 30 sec later then the first call
2.61.0.160_15-42-59.pcap
Info:
we have check when the second call is over a 1 min. later we have
the problem with the audio for the first second
Thanks
Christian
Hi griese，
Thanks for your information. I have submitted them to our R&D. Hope they will figure it out.
Hi
are there news about the problem ?
thanks
christian
i have the same issue, i sold already about 1000 yealink phones, and all of them have the same problem. this test was done on a T28 with FW 2.61.0.154 and its a freeswitch system.
here you have the file attached.
Hi deutschnaftyula,
Do you buy phones from voore or NetxUSA? Can you ask help for your distributor? They have higher priority than the forum.
They have used version 71 which is x.71.0.151.
Hi
are there news about the problem ?
thanks
christian
Are there news
we have always the problem !!!
Hi griese,
Sorry for the inconvenience. I will push our researchers with this issue again.