08-13-2021, 09:41 PM
Hi There,
i have programmed a software to use the action URLs.
The problem are the Client Desktops that usese DHCP (Laptops).
They changes often the IP-Adresses, so i have to change the IP-Adress in the actionurls to the Client.
My Question:
Is there a way to set the Action URLS from my Clientsoftware ?
the Provisioning of the Phones comes from the PBX, but the ActionURLS are set from me for every phone.
My software knows the IP-Adress of the Phone and the IP-Adress of the Client PC.
Now i will set the Actionurls on every start of the Program.
Any Ideas ?
Remark:
i had found in the Adminguide this :
http://admin:admin@192.168.200.158/servlet?phonecfg=set[&account.1.enable=1][&features.dnd.enable=1]
With that, i tried to set the ActionURLs, but there is no change and i get a cfg with only the Firmware-Version as response.
Cheers
Andreas
i have programmed a software to use the action URLs.
The problem are the Client Desktops that usese DHCP (Laptops).
They changes often the IP-Adresses, so i have to change the IP-Adress in the actionurls to the Client.
My Question:
Is there a way to set the Action URLS from my Clientsoftware ?
the Provisioning of the Phones comes from the PBX, but the ActionURLS are set from me for every phone.
My software knows the IP-Adress of the Phone and the IP-Adress of the Client PC.
Now i will set the Actionurls on every start of the Program.
Any Ideas ?
Remark:
i had found in the Adminguide this :
http://admin:admin@192.168.200.158/servlet?phonecfg=set[&account.1.enable=1][&features.dnd.enable=1]
With that, i tried to set the ActionURLs, but there is no change and i get a cfg with only the Firmware-Version as response.
Cheers
Andreas