03-02-2018, 06:05 PM
Our phone setup requires T46 users to enter a comedian mail mailbox number and password after touching the T46 message button.
I found where to program the message button in the phone Web interface.
From the documentation, I created a command to dial voice mail, pause, dial mailbox number, pause, and enter the password.
*124$Tinvite$$Cwc$$Cp4$9745$Cp2$1234#Tdtmf$
When I set this in the phone configuration and press the message button on the T46, I get a message that says, "Using secondary trunk to terminate your call."
I reduced the command string to: *124$Cp4$7091$Cp2$1234#Tdtmf$
Still get the same message.
I tried programming a DSS button and got the same result.
Further reading indicates that this function has to be provisioned in order for these strings to work:
features.enhanced_dss_keys.enable = 1
Is this correct?
Any thoughts?
Thanks.
Tom
I found where to program the message button in the phone Web interface.
From the documentation, I created a command to dial voice mail, pause, dial mailbox number, pause, and enter the password.
*124$Tinvite$$Cwc$$Cp4$9745$Cp2$1234#Tdtmf$
When I set this in the phone configuration and press the message button on the T46, I get a message that says, "Using secondary trunk to terminate your call."
I reduced the command string to: *124$Cp4$7091$Cp2$1234#Tdtmf$
Still get the same message.
I tried programming a DSS button and got the same result.
Further reading indicates that this function has to be provisioned in order for these strings to work:
features.enhanced_dss_keys.enable = 1
Is this correct?
Any thoughts?
Thanks.
Tom