Yealink Forums

Hi,

We are using a T29G version 46.82.0.20/46.82.0.30 (tried both versions so far) on an asterisk v13.

If the on/off code for the forward is configured, when activating the forward, the phone is sending the *72XXXXXXXXXX number, which is fine. When deactivating the phone is sending *73XXXXXXXXX instead of *73 which does not decativate the forward on the system.

Previous versions were deactivating the forwarding correctly by sending only the *73 with no extra number.

The exact same problem was reported with the T46 series on http://forum.yealink.com/forum/showthread.php?tid=41437 and apparently it was fixed. Can you please fix this problem on the T29 series too?

Regards,
Andrei

Hi Andrei, Good day!

This is Evan from Yealink Support Team, nice to answer this question.

This issue you mentioned is fixed via firmware xx.82.0.47, you can download it from below link. (The link is only available for 150 days)
http://sfyms.yealink.com/?ShareToken=43F...15C91B22D4

Please help test the firmware and let me know the test result.

Best Regards,
Evan You

(02-07-2018 05:30 AM)Evan_Yealink Wrote: [ -> ]Hi Andrei, Good day!

This is Evan from Yealink Support Team, nice to answer this question.

This issue you mentioned is fixed via firmware xx.82.0.47, you can download it from below link. (The link is only available for 150 days)
http://sfyms.yealink.com/?ShareToken=43F...15C91B22D4

Please help test the firmware and let me know the test result.

Best Regards,
Evan You

Hi Evan,

Thank you for that.

So far so good. The call forward feature works as expected.

I will upload the firmware on a few other handsets which are used daily.

If I encounter any problems i will let you know.

Regards,
Andrei