Yealink Forums

I challenge any one with the answer on how to successfuly integrate the T58V as a simple SIP exteNsion to hang off of a Panasonic KX-NS700/1000.

I can get it to register to the pbx and call from a system phone to the Yealink,
but i cannot call from the Yealink to a digital or slt extension without getting a "not acceptable" message
Nor, can i dial out to an outside number, dial 9 or enter pound at the end or combination of.
If it has something to do with the dial plan
i have experimented with that, but i don't think i have a clear understanding of that

Dear Customer,

Would you please follow below FAQ to turn on the event capturing, produce the issue, and then send us the config.bin file, pcap trace file, and syslog on level 6 so I can have a look?
http://support.yealink.com/faq/faqInfo?id=707
Kind Regards
Samuel Wang

Hi,

I know this is an old thread, but I have walked across the same issue only with T46S.

I have attached the file capture, performing an on net (Within the Panasonic NS700) call to an in house extension.

Thanks!

Mike

So,
all this time - we still have the same issue - I can get the T58A to register to the Panasonic NS700 - but there must be more adjustments to be made, dial plan, signaling, i just want to make it work like a single line phone, dial 9 to access SIP trunks, intercom extension to extension, transfer, etc...Does any one have any cheat sheets or setup notes - still searching

(01-09-2018 12:32 PM)Samuel_Yealink Wrote: [ -> ]Dear Customer,

Would you please follow below FAQ to turn on the event capturing, produce the issue, and then send us the config.bin file, pcap trace file, and syslog on level 6 so I can have a look?
http://support.yealink.com/faq/faqInfo?id=707
Kind Regards
Samuel Wang

here is the file[attachment=6000]