11-27-2017, 03:31 PM
I'm using Yealink T46G phones on a 3CX server and I am testing the new firmware before I push out the upgrade.
I have put this new firmware out on a few test desk phones and it's causing issues with placing and picking up shared parking slots. I've been testing to see if I can find a resolution, but so far nothing.
I do notice though in the web console of the desk phone 'Features > Pickup & Park > Call Park', that the 'Call Park Mode' setting has changed. In the newer firmware, only 'FAC' is available to use. In the older firmware that still works, located in 'Features > Call Pickup > Call Park' that the 'Call Park Mode' is set by default to 'XSI'.
The phone I'm currently testing on is a T46G with a hardware version of 28.2.0.128.0.0.0 and running firmware 28.82.0.20.
After several factory resets and firmware reinstallation, the problem persists. I was referred to this forum from the 3CX support forum. Staff of that forum informed me they were in contact with Yealink who recommended it.
I have put this new firmware out on a few test desk phones and it's causing issues with placing and picking up shared parking slots. I've been testing to see if I can find a resolution, but so far nothing.
I do notice though in the web console of the desk phone 'Features > Pickup & Park > Call Park', that the 'Call Park Mode' setting has changed. In the newer firmware, only 'FAC' is available to use. In the older firmware that still works, located in 'Features > Call Pickup > Call Park' that the 'Call Park Mode' is set by default to 'XSI'.
The phone I'm currently testing on is a T46G with a hardware version of 28.2.0.128.0.0.0 and running firmware 28.82.0.20.
After several factory resets and firmware reinstallation, the problem persists. I was referred to this forum from the 3CX support forum. Staff of that forum informed me they were in contact with Yealink who recommended it.