Hi,
Is there some way to program one of the horizontal programable keys on a T42G to park a call to extension 70?
I can configure a LineKey to do it very easily and it works well, but as far as I can tell there is no way to configure this to one of the programable soft keys.
any ideas?
tia
Hello,
Please try to configure the softkey layout, then test again.
Path: webUI>>settings>>softkey layout.
BR
klaus
Hi Klaus,
There is no option there for park call. only the following:
Empty, Mute, Swap, New Call, Switch Account, Answer, Reject. and in the Selected Softkeys column: Transfer, Hold, Conference, Cancel.
Jason
(10-19-2017 10:14 AM)Klaus Wrote: [ -> ]Hello,
Please try to configure the softkey layout, then test again.
Path: webUI>>settings>>softkey layout.
BR
klaus
Could it be achieved with macros somehow?
(10-19-2017 10:46 AM)jasonblewis Wrote: [ -> ]Hi Klaus,
There is no option there for park call. only the following:
Empty, Mute, Swap, New Call, Switch Account, Answer, Reject. and in the Selected Softkeys column: Transfer, Hold, Conference, Cancel.
Jason
(10-19-2017 10:14 AM)Klaus Wrote: [ -> ]Hello,
Please try to configure the softkey layout, then test again.
Path: webUI>>settings>>softkey layout.
BR
klaus
Please use auto p feature to configure below sentence :
bw.enable = 1
bw.xsi.enable = 1
then it will be ok.
BR
klaus
Ah thanks. this is interesting. that worked I was able to added a park key. however it then asks you for the park extension. can i program the park extension too?
(10-24-2017 02:13 AM)Klaus Wrote: [ -> ]Please use auto p feature to configure below sentence :
bw.enable = 1
bw.xsi.enable = 1
then it will be ok.
BR
klaus