Yealink Forums

Full Version: DSSKey to show Line Status
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
So this is going to be a bit of a newbie question but how would i be able to program the DSSKeys to display the outside line status from my Yeastar S20? I am using 4 FXO lines and i am sure the client will want a display status from each line.... I tried programming each Line as a separate key but lines 2-4 dont show, only Line 1. I can press the key and then the Line shows up but it picks up the next available outgoing line rather than its specific FXO port...
hi Vovais

thanks for your information

for this question , i have searched and find Yeastar S20 is a PBX which can support FXO.

for phone side , we can use BLF feature to monitor different extensions' status by sending subscribe message and receive notify message from PBX side .

so for this issue,please check if phone side had configured BLF correctly , you can refer ot below guide , page 552
http://download.support.yealink.com/down...V81_20.pdf

if configure is OK , then please provide the trace file (level 6 log file , bin file , pcap file)of phone side so that i can check if any problem with phone side .
for how to get them and check they are useful, please refer to the FAQ below:
http://support.yealink.com/faq/faqInfo?id=311

at the same time it is also advised to check with Yeastar side to see if issue can be solved faster

TKS & BR

Michael
Reference URL's