Since version 36.80.0.95 connecting a Wyse thin client into PC port on T41P creates a duplex mismatch port goes up and down every 5 seconds.. Reverting to 36.80.0.70 solves the issue. I've tried 36.80.0.130 with same issue. Also if I hard set the port to 100 Full it works fine. The Wyse is set to Auto. Tried different hardware same results.
Just test latest version. 36.81.0.25 suffers from same issue.
(02-04-2017 07:40 AM)quinlan Wrote: [ -> ]Dear Sir
Could you help load syslog to us analysis? you can refer to following link: http://support.yealink.com/faq/faqInfo?id=313
Hello,
I have taken over this issue from my colleague and I've attached the requested log files. Can you please advise? The auto-negotiate will work for a few seconds and then drop again. Only setting the phone manually to full duplex will resolve the issue which is not a plausible solution.
Thank you,
Mike