Hello !
I´m operating a T48G as VOIP-Phone at a fritzbox 7390.
The Voicemailbox is installed at the Fritzbox under **600.
This works fine.
But if there is a new voice message in the fritzbox-VoiceMailbox, the phone
doesn´t shwo this. No flashing LED at the phone.
I tried several combinations in the settimgs, but it won´t work.
What do i have to configure how in order to get a flashing LED at the T48G
if there is a new voicemessage in the Fritzbox ?
Thx Martin
Hi Martin,
did you try it out with the parameters shown in my pictures I did post in the german ip-phone-forum in the thread within you asked there? At my T46G, it is working fine with Fritzbox 7490.
Hi Werner,
yes i tried.
Wont Work !
What could be the matter ?
(12-07-2016 01:14 PM)q Wrote: [ -> ]What could be the matter ?
No real idea
The only "idea", that the FB7490 is able to send MWI to the phone and the FB7390 and the FB6490 are not able to do so. But I do not believe in this idea, I think it MUST work on the 7390 and the other FBs too. So I think you have set one or some parameters different then I did on my FB or on my T46G.
No, parameters are equal.
Seems as if FB 7390 cant´t send MWI to the Phone. But i don´t believe this.
AVM Germany told me this morning , that the MWI Feature is not available for IP-Phones connectet to the Fritzbox.
You can check this under "Telephony Devices" , "Settings of the phone device".
If there is no Option "MWI" than the Fritzbox doesn´t support this Feature for the IP-Phone you connectet.
So I´m confused abot that your´s doing.
Martin
HI Martin，
About your problem, please go to the phone web ui and refer to the attachment to configure the two parameters.
[
attachment=3988][
attachment=3989]
If the issue still exist, please kindly provide the level 6 syslog, config.bin and pace trace when you reproduce the issue to do further analysis.
About how to get the three files, please refer to the FAQ below:
http://support.yealink.com/faq/faqInfo?id=313
Best Regards,
Lucia
Hello Lucia,
i produced the "allconfig.tar. file now by make a call an speech to the voicemailbox.
Where should i send the file ?
Hello,
accidental i inserted "**600@fritz.box" instead of "**600" in the field VOICE MAIL .
What should i say, now it works fine.
Phone displays missed calls and amount of messages at the fritz box.
All other settings like Lucia wrote.
THX a lot
Martin
Hello again,
now i´m completely confused.
Dont know what happend but the feature doesn´t work again.
If there is a new voicemail at the Fritzbox the Phone doesnt show it.
Please tell me what i shoulddo so that you can tell me what is going wrong.
Phone is T48G and Fritzbox 7390
Thank you