11-04-2016, 08:59 PM
I am trying to figure out how to remote dail on a T46.
I followed this one: http://support.yealink.com/faq/faqInfo?id=388
And as far as i could google i need to set:
ActionURIShowMsgBox = 0
I downloaded the config.bin, changed it from notepad++, let the phone reboot and checked the config.bin again to test that its still in the config.
To avoid the lcd pop up (i dont have access to the phone - only on remote and i need to place a test call to do some debugging on the firewall).
Is there any other way to advoid the on screen verification?
I can see the screencapture does'nt come up until the next firmware
I followed this one: http://support.yealink.com/faq/faqInfo?id=388
And as far as i could google i need to set:
ActionURIShowMsgBox = 0
I downloaded the config.bin, changed it from notepad++, let the phone reboot and checked the config.bin again to test that its still in the config.
To avoid the lcd pop up (i dont have access to the phone - only on remote and i need to place a test call to do some debugging on the firewall).
Is there any other way to advoid the on screen verification?
I can see the screencapture does'nt come up until the next firmware