10-19-2016, 09:57 PM
Stats: Yealink T46G --- Firmware 28.80.0.130
I have been in contact with our PBX software vendor (3CX) and we are having an issue with transfers.
When a user blind transfers the phone is still “in-use” (even though the call display says nothing) --- How do we change this?
Is there a parameter I change in the config file?
This is the statement from our software vendor:
>> Yealink phones will not release the call on a blind transfer until the other side answers the call. On the display of the phone you will see that the call is ended but in reality the phone will release the call on the 200 OK. This can be proved with wireshark capture. “
I have been in contact with our PBX software vendor (3CX) and we are having an issue with transfers.
When a user blind transfers the phone is still “in-use” (even though the call display says nothing) --- How do we change this?
Is there a parameter I change in the config file?
This is the statement from our software vendor:
>> Yealink phones will not release the call on a blind transfer until the other side answers the call. On the display of the phone you will see that the call is ended but in reality the phone will release the call on the 200 OK. This can be proved with wireshark capture. “