Yealink Forums

Full Version: Firmware 71 & 72 BLF Issue
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Hello

we are receiving T26P phones with 6.71.0.141 FW
The BLF fonction on DSS Key no more works with our EPYGI ipbx
No pickup occurs when pressing the red blinking Key
Instead a number is dialed by the phone, which number is a concatenation of Extension and Value fields of DSS KEY.
when leaving extension field blank, the dialed number is the one defined in value field only.

Note :
extension watching works ( blinking on incoming call or red when busy )

when upgrading to latest FW 6.72.0.30, we have the same issue, but

when downgrading FW to 6.61.0.83, the pickup feature is recovered.

Is there something else to configure on these FW ?

Best Regards
Henri Elspass
In V71 or V72, do you disable "Dialog Info Call Pickup" or enable it? How about this value in V61?
Enter the webpage of phone->Account->Advanced, disable or enable "Dialog Info Call Pickup" and check again.
This is a duplicate issue. See existing thread: http://forum.yealink.com/forum/showthread.php?tid=1243
Reference URL's