Yealink Forums

Hello,
I have a question about Vlans. We are using T22P, T28 and T32G. Everything works fine on T22P and T28, for example we have a PC port in vlan 2 and internet port in vlan 4.
We have the same configuration in T32G and it does not work. The computer connected to the PC port does not receive IP address while phone gets ip from right vlan id 4.
Firmware: 32.70.0.130
Hardware: 22.1.2.32.0.0.0

Do we need any specific configuration for this model?

Thank you in advance for your help

Don't you use a VLAN DHCP in T2 series?
Do you enable PC port in webpage of T32G?

Hello again,

I forgot to send an informaton. The problem was with Cisco switch configuration.
T2 series works with vlan configuration for example like this:

#switchport trunk allowed vlan 101,107
#switchport mode trunk

but T32 only with:

#switchport access vlan 107
#switchport trunk native vlan 101
#switchport mode trunk